General-tools-and-instruments HT10 Instrukcja Użytkownika Pobierz pdf (Strona 11)

You can now use the software to “configure” your HT10.

Configuring the device means choosing four key parameters:

• Sampling time—How often it makes and stores

humidity and temperature measurements.

• Temperature unit—degrees Fahrenheit or Celsius

(°F or °C).

• High and low temperature alarm setpoints

• High and low humidity alarm setpoints

To begin, click on “Set up the USB Data Logger” in the

window shown in the figure above. Doing so will cause the

following window to appear.

Using your mouse, trackball or touchpad, first choose your

Temp Scale and Sample Rate (sampling time). With regard to

sampling time, using the shortest setting of 10 seconds may

Device HT10 is connected!

Fig. 3. The HT10 configuration (Setup) window

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Brak uwag

General-tools-and-instruments HT10 Instrukcja Użytkownika Strona 11