General-tools-and-instruments MSV350D Instrukcja Użytkownika Pobierz pdf (Strona 5)

Figure 2

For locating the horizontal batten or wall stud:

Place the instrument against the wall in a

horizontal position (see Figure 2). Repeat the

same procedure for locating a vertical wall stud

but move the instrument in a vertical (top to

bottom) direction.

NOTES FOR STUD SEEKING

• In case of the instrument is placed over a

dense wall surface material, such as concrete

wall, during calibration procedure; the reading

only shows difference of wall density on the

surface. It is actually not a stud.

• If by chance the instrument is placed over the

wall batten or stud during calibration, the other

studs may be hard to detect. It is suggested

that you frequently re-calibrate on various

place on the same wall to avoid the false

readings. To do so, press Scan button once and

repeat the above procedures.

• The stud detection can be carried out normally

on wallpapered walls. However, it may not

function on some types of foil-backed or

metallic fabric surfaces.

• A double width of stud will be detected around

door or window frames as a double batten or

double stud is encountered.

• A solid wood header may exist in some doors.

The stud location will not be found if the

instrument is calibrated over the header.

However, if the unit is calibrated on a normal

wall first and then moved to the header area, it

will indicate the presence of the header.

• If the wall material is especially dense or thick,

the top arrow bar icon may not appear. Instead,

Hold down

the button

“STUD”

MSV350D-FINAL- 033009:Layout 1 3/30/09 9:36 AM Page 5

1 2 3 4 5 6 7 8 9 10 ... 27 28

Brak uwag

General-tools-and-instruments MSV350D Instrukcja Użytkownika Strona 5